Our Products

Rotary Evaporator

Laboratory equipment

Jacketed Reactor

Contact Us

We Cherish All Interactions

Typical Flame Temperature for Different Fuels

Typical Flame Temperature for Different Fuels

This is a list of flame temperatures for various common fuels. Adiabatic flame temperatures for common gases are provided for air and oxygen. (For these values, the initial temperature of air, gas, and oxygen is 20 °C.) MAPP is a mixture of gases, chiefly methyl acetylene, and propadiene with other hydrocarbons.You'll get the most bang for your buck, relatively speaking, from acetylene in .

Listings in Scales, tank, Evaporators, low temperature and .

Listings in Scales, tank, Evaporators, low temperature and .

Listings in Scales, tank, Evaporators, low temperature and Switchgear & other power distribution equipment

Temperature Control of a Stirred Reactor

Temperature Control of a Stirred Reactor

The objective of this case study is to automatically maintain a temperature in stirred tank reactor with a highly exothermic reaction. This is an example of a highly nonlinear process that is prone to exponential run-away when the temperature rises too quickly.

Designing Polymerization Reaction Systems | AIChE

Designing Polymerization Reaction Systems | AIChE

The temperature drop across a heat exchanger is a function of recycle ratio. This plot is for the exchanger in Figure 4 when T – T f = 50°C. ture that is 50°C below the reactor temperature (T f = T – 50). Low recycle ratios, say R ≤ 10, require very large temperature differences.

liquid oxygen – Rocketology: NASA's Space Launch System

liquid oxygen – Rocketology: NASA's Space Launch System

But even though LH2 has the highest specific impulse, because of its low density, carrying enough LH2 to fuel the reaction needed to leave Earth's surface would require a tank too big, too heavy and with too much insulation protecting the cryogenic propellant to be .

Solid-state synthesis, magnetic and structural properties .

Solid-state synthesis, magnetic and structural properties .

However, many thin-film reactions are initiated near room temperature and even occur at cryogenic temperatures. At such low temperatures diffusion is extremely small and cannot provide atomic .

Typical Flame Temperature for Different Fuels

Typical Flame Temperature for Different Fuels

This is a list of flame temperatures for various common fuels. Adiabatic flame temperatures for common gases are provided for air and oxygen. (For these values, the initial temperature of air, gas, and oxygen is 20 °C.) MAPP is a mixture of gases, chiefly methyl acetylene, and propadiene with other hydrocarbons.You'll get the most bang for your buck, relatively speaking, from acetylene in .

Urea Decomposition and SCR Performance at Low Temperature

Urea Decomposition and SCR Performance at Low Temperature

Low Temperature Scott Sluder, John Storey, Sam Lewis, Linda Lewis, Oak Ridge National Laboratory 10th Annual DEER Workshop Coronado, CA September 2, 2004 Sponsors: DOE-OFCVT, Steve Goguen and .

Gas Treatment: Sulfatreat | Hawk Energy

Gas Treatment: Sulfatreat | Hawk Energy

For sweetening gas that is less than fully water saturated or for faster reaction speed with fully saturated gas. SulfaTreat-HP 410 For low pressure applications such as vent gas or odour control. SulfaTreat-XLP Similar to the original SulfaTreat product but with up to 2.5x the bed life. Sulfatreat HC

Dichloroethane (ethylene dichloride) – Manufacturing .

Dichloroethane (ethylene dichloride) – Manufacturing .

The reaction can be carried out at either low (20-70°C) or high (100-150°C) temperatures. The low temperature process has the advantage of low by-product formation but requires more energy to recover the EDC. The high temperature process utilises the heat of reaction in the distillation of the EDC, leading to considerable energy savings.

Low-Temperature Synthesis of TiC from Carbon-Infiltrated .

Low-Temperature Synthesis of TiC from Carbon-Infiltrated .

Carbonization of TiO2, which is a process typically used to synthesize TiC, consumes a huge amount of energy. Low-temperature synthesis of TiC from carbon-infiltrated TiO2 has been investigated in this study to develop an energy-saving process. Porous TiO2 was first obtained by hydrochloric acid leaching of ilmenite (FeTiO3) ore. Then, carbon-infiltrated TiO2 was prepared from the porous TiO2 .

Introduction to Chemical Engineering: Chemical Reaction .

Introduction to Chemical Engineering: Chemical Reaction .

The rate of each reaction then depends on the concentration of its reactants and the temperature, as described by the Arrhenius equation: r= k(T)ca Ac b B = k 0e EA RT ca Ac b B (7) where aand bare the reaction order with respect to reactant A and B, respectively. The overall order of the reaction is n= a+ b. 1.2 Material balance

Urea Decomposition and SCR Performance at Low Temperature

Urea Decomposition and SCR Performance at Low Temperature

Low Temperature Scott Sluder, John Storey, Sam Lewis, Linda Lewis, Oak Ridge National Laboratory 10th Annual DEER Workshop Coronado, CA September 2, 2004 Sponsors: DOE-OFCVT, Steve Goguen and .

Effect of Operating Conditions on CSTR performance: an .

Effect of Operating Conditions on CSTR performance: an .

[8]. Rate constants of the saponification reaction in the temperature range at various temperatures (35-55 0C) were determined and it is noticed that results obtained are in agreement with some of the literature data. Modelling and simulation study of the CSTR for complex reaction has been carried out by the

Optimization of low-temperature transesterification of low .

Optimization of low-temperature transesterification of low .

The transesterification experiments of a mixture of sunflower oil and algae oil at a constant and low reaction temperature of 50 °C were designed using RSM based on the Box-Behnken design (BBD) . Design Expert 10.0.7 software was used to perform statistical analysis and optimization.

Liquid nitrogen - Wikipedia

Liquid nitrogen - Wikipedia

Liquid nitrogen—LN 2 —is nitrogen in a liquid state at low temperature (−195.79 °C (77 K; −320 °F) boiling point at sea level).It is produced industrially by fractional distillation of liquid air.It is a colorless, low viscosity liquid that is widely used as a coolant.

How Does the Aquastat on a Boiler Work? | Hunker

How Does the Aquastat on a Boiler Work? | Hunker

Jul 17, 2017 · Set the low-temperature limit at least 20 degrees below the high-temperature limit setting. The circulator pump will lock out if the low-limit and high-limit points are too close or are accidentally mixed up, which prevents the boiler from working properly. Many home appliances require hot water that is at least 120 degrees Fahrenheit, which .

FRP Material Selection Guide - Reichhold

FRP Material Selection Guide - Reichhold

Low Temperatures 63 : Air Inhibition 63 . Thixotropes, Antimony Oxides and Other Additives 63 . process equipment, e.g. tanks, piping, duct and hood systems, reaction vessels, etc. Because of its fast cure, polymer concrete has displaced Portland cement concrete in highway bridge deck overlays where

Jacketed Heating - Chemical Processing

Jacketed Heating - Chemical Processing

Reactor temperature and output, ˚C Temperature set point Controller output, °C Temperature PV CaSe 2 Figure 3. Oscillation occurred during set-point step on a 40,000-L reactor with the reactor loop in auto and the jacket loop in cascade; a load disturbance (exothermic reaction) also took place.

Used Stainless Steel Tanks, Pressure Vessels and Reactors .

Used Stainless Steel Tanks, Pressure Vessels and Reactors .

Perry Videx has a large inventory of used and unused stainless steel and glass lined storage tanks for the food, dairy, beverage, pharmaceutical and chemical industries. Perry Videx is worldwide distributor and fabricator of stainless steel reactors from 1/2 gallon to 20,000 gallons. Perry Videx has a large inventory of Hastelloy "C" reactors, used/reglassed reactors and glass lined parts for .

Low Temperature Oxidation of n-Hexane in a Flow Reactor

Low Temperature Oxidation of n-Hexane in a Flow Reactor

Low Temperature Oxidation of n-Hexane in a Flow Reactor R. Mevel K. Chatelain P.A. Boettcher J.E. Shepherd´ Graduate Aerospace Laboratories, California Institute of Technology, Pasadena, California 91125, USA The risk of igniting a flammable mixture in fuel tank vapor space is a .

What is the fuel cell working temperature?

What is the fuel cell working temperature?

For a low temperature PEMFC, the reaction can be started at room temperature. Since it is an exothermic reaction, the temperature of the PEMFC itself increases after the reaction starts.

CHAPTER 2 CONTINUOUS STIRRED TANK REACTOR

CHAPTER 2 CONTINUOUS STIRRED TANK REACTOR

The temperature of the fluid in the tank and the jacket are measured using a thermocouple. Sensor . yield as the temperature is very low and at high temperatures, steady state . a small change in the reaction temperature thereby making the system to respond in a sluggish manner, .

Temperature Controlled Water Bath at Thomas Scientific

Temperature Controlled Water Bath at Thomas Scientific

Circulating Water Bath with 8.5L Stainless Steel Tank This stainless steel water bath is a convenient and reliable 8.5 liter bath that consistently delivers outstanding results in the lab. Precise and user-friendly temperature control Automatic water level detection system Variable water.

Dichloroethane (ethylene dichloride) – Manufacturing .

Dichloroethane (ethylene dichloride) – Manufacturing .

The reaction can be carried out at either low (20-70°C) or high (100-150°C) temperatures. The low temperature process has the advantage of low by-product formation but requires more energy to recover the EDC. The high temperature process utilises the heat of reaction in the distillation of the EDC, leading to considerable energy savings.

Low-temperature Rate Coefficients for the Reaction of .

Low-temperature Rate Coefficients for the Reaction of .

The reaction of the C2H radical with benzene is studied at low temperature using a pulsed Laval nozzle apparatus. The C2H radical is prepared by 193-nm photolysis of acetylene, and the C2H concentration is monitored using CH(A2Delta) chemiluminescence from the C2H + O2 reaction. Measurements at very .

Mining and Refining – Process

Mining and Refining – Process

The precipitation reaction is the reverse of the gibbsite dissolution reaction in the digestion stage: Al(OH) 4-+ Na + → Al(OH) 3 + Na + + OH-6. Evaporation. The spent liquor is heated through a series of heat exchangers and subsequently cooled in a series of flash tanks.

(PDF) Effect of Operating Conditions on CSTR performance .

(PDF) Effect of Operating Conditions on CSTR performance .

The reaction conversion increases from 50.2% to 58.8% corresponding to a temperature change from 25 o C to 30 o C but for a reaction temperature more than 30 o C a more sluggish behavior of change .

CHE244 - Lab Report Effect of Temperature On The Reaction .

CHE244 - Lab Report Effect of Temperature On The Reaction .

CHE244 - Lab Report Effect of Temperature On The Reaction in a CSTR (2015)

Cool Down with Liquid Nitrogen - AIChE

Cool Down with Liquid Nitrogen - AIChE

undesired oxidation reactions that can reduce product qual-ity. Liquid nitrogen (LIN) is used in innovative cooling and freezing technologies. LIN is an effective and convenient refrigerant due to its availability, low cost, and inert properties. It is also a practi-cal cryogen for most low-temperature applications because